MARRABLE CONSTRUCTIONS PTY LTD

Licensed builder — Job Card

Job Card No: JC-2214
Date issued: 19 May
Issued to: Carpentry crew

Project: Rear extension — family room and bedroom 2 (approx. 34 m²)	Site: 14 Kestrel Street, Bendigo VIC 3550
Client: T. & A. Okafor	Designer: Whitfield Design Group
Site supervisor: Priya Nair — 0400 217 884	Leading hand: Marco Bellini

Task this job card covers: Set out and frame the rear extension, install sheet flooring and hang doors per the document extracts below. Before setting out or ordering materials, reconcile the extracts against each other, against the specification, and against site measurements. Flag anything that does not line up with Priya before proceeding — do not assume, and do not scale from drawings.

Document register (confirm you are working from these revisions)

Document	No.	Revision	Dated
Floor plan	A02	C	12 May
Section A-A	A05	C	12 May
Door & window schedule	S01	C	12 May
Written specification, Job 2214	SPEC-2214	C	12 May

Extract 1 — Drawing A02 Floor Plan (Rev C) — dimensions in mm, taken to face of frame

Dimension chain across the extension (west to east):

90 ext. wall	4,500 FAMILY ROOM	90 int. wall	3,450 BED 2	90 ext. wall
8,190 OVERALL

Plan notes: D3 — 820 hinged door to Bed 2. D4 — sliding stacker door to family room, east wall. W4 — window to family room, north wall. Floor construction: refer Section A-A and specification. Do not scale — use figured dimensions.

Extract 2 — Drawing A05 Section A-A (Rev C) — notes

FFL to underside of ceiling: 2,440
Window and door head height: 2,100 above FFL
Floor: 22 mm particleboard sheet flooring on 90 × 45 MGP10 floor joists at 450 crs
Ceiling: 10 mm plasterboard on ceiling battens; roof pitch 22.5° to match existing

Extract 3 — Door & Window Schedule S01 (Rev C)

Item	Type	Size W × H (mm)	Notes
D3	Hinged, solid core	870 × 2,040	Paint finish, 3 hinges
D4	Aluminium sliding stacker	2,410 × 2,100	Glazing per spec cl. 5.1
W4	Aluminium sliding window	1,810 × 1,200	Head at 2,100 above FFL

Extract 4 — Specification SPEC-2214 (Rev C) — selected clauses

1.3	Discrepancies. In the event of a discrepancy between documents, the order of precedence is: (a) this specification; (b) figured dimensions on drawings; (c) drawings. Do not scale from drawings. Notify the builder's supervisor of any discrepancy in writing before proceeding — work affected by an unresolved discrepancy must not proceed.
3.2	Floor. 19 mm structural plywood tongue and groove flooring to AS/NZS 2269, glued and screw-fixed to joists at 150 mm centres to sheet edges and 300 mm centres intermediate.
3.4	Wall framing. 90 × 45 MGP10 studs at 450 mm centres. All framing to AS 1684.
3.6	Doors. Internal doors solid core, 2,040 mm high, hung on 3 hinges; sizes per schedule S01.

Supervisor's note (Priya Nair): Check the chain dimensions add up, check door and window sizes against the schedule, and check floor and framing details against the spec before you cut anything or place orders. If any two documents disagree, stop and call me — put it in writing so the designer can issue a formal answer.